High Setting; Additional Dtl - Panasonic SPX900 Operating Instructions Manual

8-3-6

HIGH SETTING

Items/ Adjustable
Data Saved Range
MASTER –3dB Select the master gain from –3, 0, 3, 6, 9,
12, 15, 18, 21, 24, 27, or 30dB.
GAIN :
18dB
:
S C U F E 30dB
H.DTL LEVEL 00 Set H.DTL.
:
12
:
S C U F E 63
V.DTL LEVEL 00 Set V.DTL LEVEL.
:
17
:
S C U F E 31
DTL CORING 00 Set DTL CORING.
:
08
:
S C U F E 15
H.DTL FREQ. 00 Set a frequency (DTL width) at which H.DTL
: is added. The greater the value, the higher
20
the frequency (the narrower the DTL).
:
S C U F E
31
LEVEL 0 Set LEVEL DEPEND.
DEPEND.) No DTL is added to the portion whose
:
3
brightness is the setting value or less.
:
When the GAMMA MODE SEL item is set to
5
STD, each setting value represents
brightness levels, as follows: 0 = about 0%,
1 = about 4%, 2 = about 8%, 3 = about 12%,
4 = about 16%, 5 = about 20%.
S C U F E
MASTER 0.35 Set MASTER GAMMA in 0.01 steps.
GAMMA :
0.55
:
S C U F E 0.75
BLACK –3 Set the gamma curb for dark spots.
STRETCH :
OFF
:
S C U F E +3
MATRIX OFF Select the color correction table.
TABLE A
B
S C U F E
COLOR ON Set the color correction to ON or OFF.
CORRECT OFF
S C U F E
8-3-7
Remarks
KNEE APE LVL OFF
CHROMA DTL OFF
DTL GAIN(+)
DTL GAIN(–)
DTL CLIP
DTL SOURCE
H.DTL LINE MIX 1H
<Note>
The items indicated by
SW( ) R/W in the <SD CARD R/W SELECT> screen. The items
without
Please refer to [8-7-2 SD CARD R/W SELECT] for more
information.
The ____ in the Adjustable Range column indicates the preset
mode.

ADDITIONAL DTL

Items/ Adjustable
Data Saved Range
Set KNEE APE LEVEL.
1
2
:
S C U F E
5
Set the chroma detail.
0 Detects the chroma edge and superimposes
it on Y to enhance H.DTL. A greater value
:
5
increases the correction.
S C U F E
–31 Adjust the detail level toward + (upwards).
:
+00
:
S C U F E
+31
–31 Adjust the detail level toward the –
(downwards).
:
+00
:
S C U F E
+31
00 Adjust the detail signal clip towards the +
: direction.
63
S C U F E
(R+G)/2 Set the signal source for detail signal
(G+B)/2 components.
2G+R+B /4
(3G+R)/4
R
G
S C U F E
Set the scan line to generate the H.DTL
signal.
2H
S C U F E
CORNER DTL ON ON/OFF switching for CORNER DTL mode,
which enhances the resolution around the
OFF
screen perimeter.
S C U F E
are the setting items for PAINT MENU
are the setting items for PAINT MENU LEVEL R/W.
Remarks
97
8