Table of Contents
Advertisement
The oven door can close if you try to
remove the internal glass panel before
you remove the oven door.
CAUTION! Do not use the appliance
without the internal glass panel.
1. Open the door fully and hold the two door
hinges.
2. Lift and turn the levers on the two hinges.
3. Close the oven door halfway to the first
opening position. Then pull forward and remove
the door from its seat.
14
4. Put the door on a soft cloth on a stable surface.
5. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
2
B
6. Pull the door trim to the front to remove it.
7. Hold the door glass panel by its top edge and
carefully pull it out. Make sure the glass slides
out of the supports completely.
8. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, install the glass
panel and the oven door. Do the above steps in the
opposite sequence.
The screen-printing zone must face the inner side
of the door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you install the internal glass panel in
the seats correctly.
1
Advertisement
Table of Contents
