Biostar TB360-BTC PRO Manual page 17

Install Two Power Supply Rule:
You can install your two power supply by following steps:
1. The 24-pins ATX power connector of power supply1 is connected to ATXPWR1.
2. The 8-pins or 4-pins ATX power connector of power supply1 is connected to ATXPWR3.
3. The 24-pins ATX power connector of power supply2 is connected to ATXPWR2.
Note
» Ensure proper pin connecting to your ATX power connector, wrong connection may damage your
motherboard.
AUXPWR1/ AUXPWR2: PCIe Power Source Connector
The connector provides +12V to the PCIe power circuit.
TB360-BTC PRO / TB360-BTC+ / TB360-BTC Expert
Pin
1
2
3
4
5
6
Chapter 2: Hardware Installation | 17
Assignment
+12V_Output
+12V_Output
+12V_Output
Ground
Ground
Ground