Setting Up Your System; Connect Dvr To Power; Connect Mouse To Dvr; Connect Dvr To Monitor - Uniden Guardian G7404D1 Owner's Manual

Images in these installation procedures show the back panel of the G6840D1. Other
models' back panels will be different, but similar.
Basic setup connects the DVR to all peripheral equipment (cameras, mouse, monitor, etc) and
power. Once connected, your system is ready for use through the DVR's menu system.
You can set up your system in 2 stages - installing your system hardware and then setting up
basic configuration. Each stage has separate steps.
STAGE 1 - Install System Hardware

• Connect DVR to Power

• Connect Mouse to DVR

• Connect DVR to Monitor

• Connect Ethernet Cable
• Connect Cameras to DVR and Power
• Install Cameras
STAGE 2 - Basic System Configuration
• Complete Wizard and Log In
• Set Password
• Set Screen Resolution
• Set Motion Sensitivity
CONNECT DVR TO POWER
1. Connect the DVR to 12V power using the 12V 2A power adapter
(supplied).
2. Connect the power adapter to a surge protector plugged into 120V indoor power.
CONNECT MOUSE TO DVR
Connect the mouse to the DVR at the labeled USB port on the back of the
DVR.
CONNECT DVR TO MONITOR
There are three different ways to connect the DVR and monitor, depending on what type of
monitor port connection is available.
8

SETTING UP YOUR SYSTEM