Mounting Using Anchor Screws - D-Link DWL-6620APS Quick Installation Manual

• Manage the access point from the
computer via the Unified Wireless
Switch or Wireless Controller:
Connect the access point to a Unified
Wireless Switch or Wireless Controller.
Connect your computer to the same
network as that of the Unified Wireless
Switch or Wireless Controller. Log in
to the Unified Wireless Switch web
administration page or Wireless
Controller web administration page. For
the default login information please see
Unified Wireless Switch user manual or
Wireless Controller user manual.
Mounting Options
You can mount the DWL-6620APS access
point on any of the following types of
surfaces:
• Solid surface wall or ceiling
• Tabletop
Cable Requirement
Use a CAT 5 cable with an even sheath.
The Ethernet ports on the DWL-6620APS
access point cannot accept a CAT 5 cable
that has an uneven sheath; the RJ-45
connector on the cable will not fit properly
Into the receptacle on the access point.
Wall Installation Recommendations
If you plan to install the DWL-6620APS on a
wall or other vertical surfaces, orient the top
of the access point (the side with the LEDs)
toward the intended coverage area. The
radio antennas transmit through the top of
the access point but not through the bottom
(where the bracket is).
4 D-Link DWL-6620APS Quick Install Guide
Warning: The DWL-6620APS is designed to
receive PoE power only from an 802.3at-
compliant source, or from a D-Link-approved
power adapter. Connecting an access point
to a Power over Ethernet (PoE) device that
is not approved by D-Link can damage the
equipment.
Warning: This product is to be connected
only to indoor PoE networks with no outdoor
cable routing.
Mounting Using Anchor
Screws
Installation
1. Place the plastic wall mounting ring on a
wall or ceiling. Mark the points where you
will insert the screws, then remove the
mounting ring.
2. Drill holes in the marked points and
insert the plastic wall anchors.
3. Use the supplied screws to attach the
mounting ring to the wall.
4. Plug the CAT 5 cable into the LAN port on
the access point.