Installation - D-Link DWL-6620APS Quick Installation Manual

Interfaces
Figure 2. DWL-6620APS Rear Panel

Installation

Power on the Access Point
To power on the DWL-6620APS, you can use
one of the following methods:
• Connect the supplied power adapter.
• Plug one end of an Ethernet cable into
the LAN 1 port of the DWL-6620APS and
the other end into a port on a PoE switch
or injector.
OR
Configure the Access Point
To set up and manage the DWL-6620APS,
use one of the following methods:
Manage the access point from
•
the computer: Connect the access
point and your computer directly via a
straight-through Ethernet cable. Ensure
your computer is configured with a
static IP address in the 10.90.90.0/24
subnet. Launch a web browser, type the
default IP address of the access point
(http://10.90.90.91), then press Enter.
To log in, use the default login
information:
Username: admin
Password: admin
• Manage the access point from the
computer via the switch or router:
Connect the access point and your
computer to the same switch or router.
If the access point did not acquire an
IP address from a DHCP server on
the network, enter 10.90.90.91 in the
address field of your browser, which
is the default IP address of the access
point. If you used a DHCP server on
your network to automatically configure
network information for the access point,
enter the new IP address of the access
point into the web browser. To log in, use
the default login information:
Username: admin
Password: admin
D-Link DWL-6620APS Quick Install Guide 3