Intermec PB50 User Manual page 39

PB50 Mobile Label and Receipt Printer User's Guide
The PB50 supports these authentication modes: none, WEP, WPA
Personal and Enterprise mode (802.1x authentication), WPA2
Personal and Enterprise mode (802.1x authentication).
Note: WPA and WPA2 Enterprise mode currently support PEAP,
TTLS, and LEAP. For LEAP authentication, the PB50 supports Open
EAP, but does not support Network EAP.
To set up the PB50 to work in your wireless network, you will need:
Serial cable (P/N 075497-001)
•
• Host PC running Windows or Linux
• Serial port software such as HyperTerminal
Note: If you are using IPL commands with HyperTerminal, you may
want to be able to see the commands as you type them on your screen.
For help, see "Changing Configuration Settings Using the
Command Line" on page
To set up the PB50 for wireless communications
1 Connect the 8-pin circular DIN connector to the serial port on the
PB50.
2 Connect the other end of the serial cable to a serial port on the
back of your PC or to a serial adapter on your mobile computer.
3 Open HyperTerminal on your PC and configure the following
parameters for the serial port:
Parameter
Baud rate
Data bits
Parity
Stop bits
Chapter 2 — Configuring the PB50
25.
Default Setting
115200
8
None
1
29