Dell Latitude 7530 Service Manual page 83

Steps
1. Align the screw holes on the keyboard to the screw holes on the keyboard support plate and place the keyboard on the
keyboard support plate.
2. Replace the two screws (M2x2) to secure the keyboard to the keyboard support plate.
3. Align and place the keyboard assembly in to its slot in the computer.
4. For computers shipped with an aluminum palm-rest, replace the 19 screws (M1.6x1.7) to secure the keyboard assembly to
the computer.
5. For computers shipped with a carbon fiber palm-rest, replace the 30 screws (M1.6x1.7) to secure the keyboard assembly to
the computer.
6. Connect the keyboard backlight flexible printed circuit cable to the connector on the touchpad module.
NOTE: This step applies only to computers shipped with a keyboard backlight installed.
7. Connect the keyboard flexible printed circuit cable to the connector on the touchpad module.
8. Adhere the smart card reader flexible flat cable to the back of the keyboard.
NOTE: This step applies only to computers shipped with a smart card reader installed.
9. Adhere the touchpad flexible flat cable to the back of the keyboard.
10. Adhere the USH daughter-board flexible flat cable to the back of the keyboard.
Removing and installing components 83