Dell Latitude 7530 Service Manual page 34

Steps
1. Place the thermal module on the system board.
2. Align the screw holes on the thermal module to the screw holes on the system board.
3. Replace the two screws (M2x2.5) to secure the thermal fan and four screws (M2x2.5) to secure the thermal heat-sink to
the system board.
NOTE: Replace the four screws (M2x2.5) in the sequential order mentioned on the thermal heat-sink [1 > 2 > 3 > 4].
4. Route the main-speaker cable into its routing guides, along the bottom side of the thermal fan.
34 Removing and installing components