Installation - Miele PWM514 Operating And Installation Instructions

Before securing the Connector Box
- The Connector Box must be screwed into place properly on site.
The dimensions of the holes to be drilled into the wall are quoted in
Fig.  in the "" chapter at the end of these operating and
installation instructions.
- Alternatively, the Connector Box can be attached to the wall using
the adhesive strips provided. If you choose this option, please note:
– The adhesive strips are attached along the outer edges and in
the centre of the rear panel. See Fig.  in "" at the end of
these operating and installation instructions.
– The surface of the wall must be smooth and solid with no
traces of grease or dust.
– It must not be covered with textured wallpaper, textured
plaster, or any other surface finish with inadequate adhesion
properties.
– The maximum mounting height must not exceed 1.5 m.
Do not install the Connector Box above uncovered water holes,
drain channels, or similar systems.
 Risk of electric shock caused by the Connector Box falling
down off the wall and into water.
If it is not secured properly and correctly, the Connector Box can
fall down off the wall, causing an electric shock.
If a Connector Box falls down off the wall, it must be taken out of
service immediately. Replace the Connector Box with a new one or
have it checked by Miele Professional Service.
Carrying out the installation
Service and repair work must only be carried out by a suitably
qualified electrician in accordance with all appropriate local and
national safety requirements.
Disconnect the Miele Professional washing machine from the mains

voltage.
Attach the Connector Box to the wall using the 4 screws (4 x 40)

and plugs (S6) provided. See Fig.  in "".
Alternatively, the Connector Box can be attached to the wall using

the adhesive strips provided. See Fig.  in "".
Establish the connection between the Connector Box and the Miele

Professional machine and the external hardware (e.g. payment
device).
When connecting external hardware provided by other
manufacturers, the cable cross-section must not be less than 1 mm
with a maximum cable length of 2.5 m.
en-AU, NZ - Installation
2
25