Table of Contents
Advertisement
Changing modes
To use a mode, press the corresponding mode key.
1
Press the mode key of the mode you wish to use.
●
●
Note
The functions of some keys and display contents vary depending on the mode. For key
●
functions and display contents in each mode, refer to the operation manual for that mode.
Storing a mode change
"Storing a mode change" means changing the mode after the current job is finished.
The mode change takes place when the next job is executed.
Copy job
●
Fax scan job
●
Scan job
●
Direct transmission job
●
1
Press a mode key while a job is being executed.
●
●
●
Note
To cancel a stored mode change, press the mode key once again. When the mode
●
change is cancelled, the display reverts to its previous state and the light of the stored
mode goes off.
Conditions in which the mode cannot be changed
The mode cannot be changed when the machine is in the following states:
A key operator program is being used.
●
The tray paper size is being set.
●
An interrupt in copy mode is taking place.
●
During a programming procedure in fax mode.
●
The machine cover is open.
●
Downloaded from:
http://www.usersmanualguide.com/
The machine changes to the selected mode and the mode light illuminates.
The following illustration shows the model with the most features installed.
The mode change is stored.
When a mode change is stored, the light of the current mode continues to illuminate
steadily, and the light of the stored mode blinks.
The display shows: "Please wait. The mode can only be changed after the present
job is finished."
Multi-Access
4
Advertisement
Table of Contents
