Switching On And Off; Before Using For The First Time; Operating The Wine Conditioning Unit; Switching The Wine Conditioning Unit On - Miele KWT 6322 UG Operating And Installation Instructions

Switching on and off

Before using for the first time

Packaging material
 Remove all packaging material from
the inside of the appliance.
Protective foil (depending on model)
Stainless steel surfaces have a layer of
protective foil to prevent scratching dur-
ing transportation.
 Do not remove the foil until the wine
conditioning unit has been installed in
its final location. Start at one of the
top corners.
Cleaning the wine unit
Please refer to the relevant instruc-
tions in "Cleaning and care".
 Clean the inside of the appliance and
the accessories.
22
Operating the wine condition-
ing unit
A light touch of the finger on the
sensors is all that is required to operate
this wine conditioning unit.
Every touch of a sensor is confirmed
with an audible tone. This tone can be
switched off (see "Selecting further set-
tings" – "Audible tones ").
Switching the wine conditioning unit
on
When the wine conditioning unit is con-
nected to the electrical supply, the
power connection symbol  will ap-
pear in the display after a short while.
 Touch the On/Off control.
The power connection symbol  will
go out and the wine conditioning unit
will start to cool.
The selected wine conditioning zone
will be highlighted yellow and the tem-
perature of the selected zone will show
in the display.
The first time the appliance is turned
on, the sensors for the wine condition-
ing zones and the alarm symbol  will
flash until the selected temperature has
been reached in the zones.
As soon as the set temperature has
been reached, the sensor for the re-
spective wine conditioning zone will
light up constantly and the alarm sym-
bol  will go out.