Dell XPS 13 Plus 9320 Service Manual page 30

About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
Steps
1. Loosen the three captive screws (M1.6x2) that secure the display-assembly cable bracket to the system board.
2. Lift the display-assembly cable bracket off the system board.
3. Disconnect the camera cable and the display cable from the system board.
4. Remove the three screws (M1.6x2.5) that secure the camera and display-assembly cables holder to the system board.
5. Open the display to a 90-degree angle and place the computer at the edge of a flat table.
6. Remove the three screws (M1.6x2.5) that secure the camera and display-assembly cables holder to the system board.
30 Removing and installing components