Installing The Heat Sink; Display Assembly; Removing The Display Assembly - Dell XPS 13 Plus 9320 Service Manual

Installing the heat sink

Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: Incorrect alignment of the heat sink can damage the system board and processor.
NOTE: If either the system board or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure
that thermal conductivity is achieved.
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes of the heat sink with the screw holes of the system board.
2. In sequential order (1>2>3>4), tighten the four captive screws that secure the heat sink to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in

Display assembly

Removing the display assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components 29