SAFETY AND EMERGENCY FEATURES
Seat belts-Shoulder belt anchor
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or replaced,
turn the "POWER" switch to ON mode and press and hold the "
until indicator blinks three times. Let the vehicle sit for a few minutes to allow
initialization to complete.
Refer to the load label on the door jamb or the Owner's Manual for tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains
on, take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or changes
in tire pressure from natural air leakage. If the system has not been initialized
recently, setting the tire pressures to factory specifications should turn off the light.
Push up, or squeeze
lock release to lower
System reset initialization
1. Push and hold "
SET" button until
the indicator blinks three times.
2. Wait a few minutes to allow
initialization to complete.
SET" button
24
Spare tire & tools
Tool location
Luggage floor cover
Jack
Jack handle
Spare tire
Tool tray
Wheel nut wrench
Removing the spare tire
(1)
(1) Remove the tool tray.
Refer to the Owner's Manual for tire changing and jack positioning procedures.
Trunk-Internal release
Pull up
(2)
(2) Loosen the center fastener that
secures the spare tire.
25