Table of Contents
Advertisement
Sharpening the Next Cutter
Use the setting for the master cutter to
sharpen all the other cutters in the row.
:
Open the clamping lever.
:
Pull the chain along to the next
cutter in the row – push cutter
against the stop.
3
Make sure the stop (3) always
locates properly against the back of
the cutter to be sharpened.
:
Close the clamping lever.
:
Sharpen the cutter.
:
Repeat the procedure until all
cutters in one row have been
sharpened.
FG 2
Sharpening the Second Row of
Cutters
1
:
Swing the filing frame upwards and
loosen the nut (1).
:
Lift the guide clear of the teeth and
turn it to the same filing angle on the
opposite side.
:
Tighten down the nut.
:
Turn the chain rest 180°, as
described under "Setting Up".
:
Reset the file.
:
Swing the filing frame down.
:
Position the round file between the
side plate and depth gauge of the
first cutter in the second row.
English
21
Advertisement
Table of Contents
