Carrier 09AZ091-182 Installation, Start-Up And Service Instructions Manual page 15

I. PRELIMINARY INFORMATION
COMPRESSOR BEARING UNIT:
09AZ UNIT:
FIELD-INSTALLED ACCESSORIES ________________________________________________________________________
________________________________________________________________________________________________________
II. PRE-START-UP
INDOOR/COMPRESSOR UNIT
IS THERE ANY SHIPPING DAMAGE? ___________________ (Y/N) ________
IF SO, WHERE: __________________________________________________________________________________________
WILL THIS DAMAGE PREVENT UNIT START-UP?
CHECK POWER SUPPLY. DOES IT AGREE WITH UNIT?
HAS THE GROUND WIRE BEEN CONNECTED:
HAS THE CIRCUIT PROTECTION BEEN SIZED AND INSTALLED PROPERLY?
ARE THE POWER WIRES TO THE UNIT SIZED AND INSTALLED PROPERLY?
HAVE FAN AND MOTOR PULLEYS BEEN CHECKED FOR PROPER ALIGNMENT? (Y/N) ________
DO THE FAN BELTS HAVE PROPER TENSION?
HAS CORRECT FAN ROTATION BEEN CONFIRMED?
HAS WATER BEEN PLACED IN DRAIN PAN TO CONFIRM PROPER DAINAGE?
ARE PROPER AIR FILTERS IN PLACE?
CONTROLS
HAVE THERMOSTAT, INDOOR-FAN CONTROL AND CONDENSER FAN CONTROL RELAY WIRING
CONNECTIONS BEEN MADE AND CHECKED?
ARE ALL WIRING TERMINALS (including main power supply) TIGHT? (Y/N) ________
HAS CRANKCASE HEATER (IF EQUIPPED) ON UNIT BEEN ENERGIZED FOR 24 HOURS? (Y/N) ________
09AZ UNIT
CHECK POWER SUPPLY. DOES IT AGREE WITH UNIT?
HAS THE GROUND WIRE BEEN CONNECTED?
HAS THE CIRCUIT PROTECTION BEEN SIZED AND INSTALLED PROPERLY?
ARE THE POWER WIRES TO THE UNIT SIZED AND INSTALLED PROPERLY?
HAS UNIT BEEN PROPERLY SECURED TO BUILDING STRUCTURE?
HAS CORRECT FAN ROTATION BEEN CONFIRMED?
PIPING
HAVE LEAK CHECKS BEEN MADE AT COMPRESSOR, CONDENSER, EVAPORATOR, TXV's
(Thermostatic Expansion Valve), SOLENOID VALVES, FILTER DRIERS, AND FUSIBLE PLUGS WITH A
LEAK DETECTOR?
LOCATE, REPAIR, AND REPORT ANY LEAKS
HAVE ALL COMPRESSOR SERVICE VALVES BEEN FULLY OPENED (Backseated)? (Y/N) ________
HAVE LIQUID LINE SERVICE VALVES BEEN OPENED?
IS THE OIL LEVEL IN THE COMPRESSOR CRANKCASE ON THE UNIT IN VIEW IN THE COMPRESSOR SIGHT
GLASS (IF APPROPRIATE)?
HAS CONDENSER PRESSURE RELIEF BEEN PROVIDED? (Y/N) ________
Downloaded from ManualsNet.com
MODEL NO. ___________________
MODEL NO. ___________________
(Y/N) ________
search engine
START-UP CHECKLIST
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
CL-1
SERIAL NO. ___________________
SERIAL NO. ___________________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________
(Y/N) ________