Switch Circuit Breakers; No-Wake Mode/Cruise Assist Switch; Operating The Boat With A Minimal Wake (No-Wake Mode) - Yamaha AR195 2019 Owner's/Operator's Manual

Instrument operation

Switch circuit breakers

The electrical circuit for each switch is pro-
tected by a circuit breaker. If the button pops
out, push it back in with your finger. If it pops
out again, ask a Yamaha Boat Dealer to in-
spect the electrical system.
BLOWER
1
1 Switch circuit breaker
CTSY
NAV/ANC
LIGHTS
1 1
1 Switch circuit breaker

No-wake mode/cruise assist switch

This switch activates and sets the no-wake
mode, cruise assist, and reverse RPM con-
trol.
42
BILGE HORN
1 1
CTSY
NAV/ANC
LIGHTS
1 No-wake mode/cruise assist switch
To operate the no-wake mode and cruise as-
sist, see the following sections. To activate
the reverse RPM control, see "Reverse RPM
control" on page 43.
Operating the boat with a minimal
wake (no-wake mode)
The no-wake mode is useful for operating the
boat at a steady speed with a minimal wake.
This is especially convenient when traveling
in harbors, channels, or other areas posted
with low speed limits as "no wake zones".
The no-wake mode can be used only when
the engine is operating at idle speed.
To activate the no-wake mode:
(1) Put the remote control lever in the TDE
position or forward position so that the
engine is operating at idle speed.
(2) Push the plus side of the no-wake
mode/cruise assist switch. Once "No
Wake Mode" is displayed in the multi-
function meter, the no-wake mode is ac-
tivated.
BILGE HORN
1