Jacking And Lifting - Tesla MODEL 3 2012 Owner's Manual

Jacking Procedure
Follow the steps below to lift Model 3. Ensure
that any non-Tesla repair facility is aware of
these lifting points.
1. Position Model 3 centrally between the lift
posts.
2. Position the lift arm pads under the
designated body lift points at the
locations shown.
WARNING: DO NOT position the
lift arm pads under the Battery or
side rails, as shown in red.
3. Adjust the height and position of the lift
arm pads to ensure that they are correctly
located.
4. With assistance, raise the lift to the
desired height, ensuring the lift arm pads
remain in their correct positions.
5. Engage any lift safety locks. Follow the lift
manufacturer's instructions.
WARNING: Never raise Model 3 when
the charge cable is connected, even if
charging is not in progress.
WARNING: Do not work on an
incorrectly supported vehicle. Doing
so can cause serious damage, bodily
injury, or death.
CAUTION: DO NOT lift from under the
Battery or side rails. Place the lift arm
pads under the designated body lift
points only. The locations shown are
the only approved lifting points for
Model 3. Lifting at any other points
can cause damage. Damage caused
by incorrectly lifting Model 3 is not
covered by the warranty.
Maintenance

Jacking and Lifting

213