Wolf CG365P/S Manual page 5

REMOVE ALL SPARK MODULES (continued)
7 Remove the spark module from the unit.
Remove the Burner Box Bottom Panel
1 Use a Phillips screwdriver to remove the screws from the
burner box bottom panel.
2 Remove the harness from the wire retention clip.
3 Remove the burner box bottom panel.
Igniter
Burner Box
Brackets
Bottom Panel
828389 REV. A 06/2018
CG Contemporary Gas Cooktop Service Manual
BURNER BOX BOTTOM PANEL INSTALLATION
Install the Burner Box Bottom Panel
1 Insert the harness into the wire retention clip.
2 Place the burner box bottom panel on the unit.
3 Use a Phillips screwdriver to install the screws into the
burner box bottom panel.
Install All Spark Modules
To install each spark module:
1 Place the spark module onto the igniter bracket.
2 Use a Phillips screwdriver to install the screws holding the
spark module to the igniter bracket.
3 Connect the white wire connector to the neutral (N)
terminal.
4 Connect the red wire connector to the L1 terminal.
5 Connect the electrode wire to the spark module.
6 Raise the screw side of the igniter bracket.
7 Use a
the igniter bracket to the burner box.
MANIFOLD BOTTOM COVER REMOVAL
The manifold bottom cover is located on the bottom of the
manifold behind the cabinet face. Removing the manifold
bottom cover allows access to the AC-DC rectifiers and
manifold harness.
TIP: The manifold bottom cover may not be removable
depending on the cabinet design.
Remove the Manifold Bottom Cover
1 Use a Phillips screwdriver to remove the screws from the
manifold bottom cover.
4
1
/ " nut driver or socket to install the screw holding
4
service.subzero.com