Wolf CG365P/S Manual page 15

Remove All Bezels
To remove each bezel:
3
Use a / " socket to remove the bezel from the unit.
4
Remove the Light Module
1 Pull the light module forward out of the receptacle.
2 Disconnect the AC-DC rectifier wire connector from the light
module.
Uninstall the Unit
Remove the unit from the installation.
Remove the Receptacle
1 Use a Phillips screwdriver to remove the screws from the
receptacle.
828389 REV. A 06/2018
CG Contemporary Gas Cooktop Service Manual
2 Remove the receptacle from the burner valve.
TIP: The spacer(s) typically remain attached to the receptacle.
RECEPTACLE INSTALLATION
Install the Receptacle
1 Install the receptacle onto the burner valve.
2 Use a Phillips screwdriver to install the screws into the
receptacle.
Install the Unit
Install the unit.
Install the Light Module
1 Connect the AC-DC rectifier to the light module.
2 Insert the tabs of the light module into the receptacle.
3 Push the light module into the receptacle.
Install All Bezels
To install each bezel:
1 Insert the bezel into the unit.
2 Use a
Install All Knobs
Push each knob onto each valve shaft.
14
3
/ " socket to install the bezel on the unit.
4
service.subzero.com