English CORDLESS COMPACT 13 mm DRILL/DRIVER/HAMMERDRILL DCD708, DCD709 Congratulations! may differ. This may significantly increase the exposure level over the total working period. You have chosen a D WALT tool. Years of experience, thorough An estimation of the level of exposure to vibration should product development and innovation make D WALT one of the also take into account the times when the tool is switched...
English 4) Power Tool Use and Care Unmodified plugs and matching outlets will reduce risk of electric shock. a ) Do not force the power tool. Use the correct power b ) Avoid body contact with earthed or grounded tool for your application. The correct power tool surfaces such as pipes, radiators, ranges and will do the job better and safer at the rate for which it refrigerators.
English Apply pressure only in direct line with the bit and do not unpredictable behaviour resulting in fire, explosion or risk • of injury. apply excessive pressure. Bits can bend causing breakage or loss of control, resulting in personal injury.cushion and limit f ) Do not expose a battery pack or tool to fire or excessive temperature.
English Disconnect the charger from the outlet before • Before using charger, read all instructions and cautionary • markings on charger, battery pack, and product using attempting any cleaning. This will reduce the risk of electric shock. Removing the battery pack will not reduce battery pack.
English Do not store or use the tool and battery pack in The DCB118 charger is equipped with an internal fan designed • locations where the temperature may reach or exceed to cool the battery pack. The fan will turn on automatically 40 ˚C (104 ˚F) (such as outside sheds or metal buildings when the battery pack needs to be cooled.
English nOTE: Battery packs should not be stored completely of the UN Recommendations on the Transport of Dangerous depleted of charge. The battery pack will need to be recharged Goods Manual of Tests and Criteria. before use. In most instances, shipping a D WALT battery pack will be excepted from being classified as a fully regulated Class Labels on Charger and Battery Pack...
English 1 Charger Chuck sleeve 1 Belt hook (included with some models) Keyless chuck 1 Magnetic bit holder (included with some models) Belt hook (included with some models) 1 Li‑Ion battery pack (C1, D1, E1, G1, H1, L1, M1, P1, Q1, S1, T1, Screw U1, X1, Y1, Z1 models) Magnetic bit holder (included with some models)
Page 13
English Speed Selection (Fig. A) in the battery is below the usable limit, the fuel gauge will not illuminate and the battery will need to be recharged. The tool features two speed settings for nOTE: The fuel gauge is only an indication of the charge left on greater versatility. nOTE: Do not change speeds when the tool the battery pack.
English OPERATION Recommendations for screwdriving • Start with lower torque settings, then advance to higher Instructions for Use torque settings to avoid damage to the workpiece or fastener. WARNING: Always observe the safety instructions and • Make some practice runs in scrap or on unseen areas of the applicable regulations.
English Rechargeable Battery Pack • A smooth even flow of material indicates the proper drilling rate. This long life battery pack must be recharged when it fails to • Drill straight, keeping the bit at a right angle to the work. Do produce sufficient power on jobs which were easily done before.