TP-Link TL-WA3001 User Manual page 24

Chapter 4
• To enable or disable OFDMA:
OFDMA enables multiple users to transmit data simultaneously, and thus greatly
improves speed and efficiency. Noted that only when your clients also support OFDMA,
can you fully enjoy the benefits. It is disabled by default.
1. Go to Wireless > Wireless
2. Enable OFDMA.
• To enable or disable TWT:
TWT (Target Wake Time) allows 802.11ax access points and clients to negotiate their
periods to transmit and receive data packets. Clients only wake up at TWT sessions and
remain in sleep mode for the rest of the time, which significantly extend their battery
life. It is disabled by default.
1. Go to Wireless > Wireless
2. Enable TWT.
• To use the Smart Connect function:
Smart Connect combines the 2.4 GHz and 5 GHz bands and assigns your devices
between them to balance network demands.
1. Go to Wireless > Wireless
2. Enable Smart Connect.
3. Keep the default values or set a new SSID and password, and click SAVE. This SSID
and password will be applied for the 2.4 GHz and 5 GHz wireless networks. If you want
to configure the wireless settings separately for each band, deselect the checkbox
to disable this feature.
• To enable or disable a wireless band:
1. Go to Wireless > Wireless
2. The wireless bands are enabled by default. If you want to disable a wireless band, just
deselect its Enable
• To change the wireless network name (SSID) and wireless password:
1. Go to Wireless > Wireless
2. Create a new SSID in
network in Password. The value is case-sensitive.
Note: If you change the wireless settings with a wireless device, you will be disconnected when the settings are
effective. Please write down the new SSID and password for future use.
• To hide SSID:
Settings.
Settings.
Settings.
Settings.
checkbox.
Settings.
Network Name (SSID) and customize the password for the
Wireless Settings
21