Table of Contents
Advertisement
Installation
Example of installation on
the chassis
1
Place the amplifier in the desired instal-
lation location.
Insert the supplied tapping screws (4 mm ×
18 mm (5/32 in. × 3/4 in.)) into the screw holes
and push on the screws with a screwdriver so
they make an imprint where the installation
holes are to be located.
2
Drill 2.5 mm (3/32 in.) diameter holes in
the chassis.
3
Install the amplifier with the use of
supplied tapping screws (4 mm × 18 mm
(5/32 in. × 3/4 in.)).
3
2
1
1 Tapping-screws (4 mm × 18 mm (5/32 in. ×
3/4 in.))
2 Drill a 2.5 mm (3/32 in.) diameter hole
3 Installation surface
4 Hole-to-hole distance: 229.5 mm (9-1/32 in.)
5 Hole-to-hole distance: 191.5 mm
(7-17/32 in.)
4
Attach the fuse cover and panel cover.
Attach the panel cover to the amplifier using
the supplied machine screws (3 mm × 10 mm
(1/8 in. × 3/8 in.)).
4
5
En
Machine screws (3 mm × 10 mm (1/8 in. × 3/
8 in.))
When installing the amplifier in a place that is
prone to getting wet, install it to a wall with
the power/speaker output terminals and RCA
jacks on the left and right sides.
Advertisement
Table of Contents
