Lockout - York D835 Manual

Lockout

WARNING!
ALL INFORMATION ON THIS PAGE IS
WARNING INFORMATION!
FOLLOW A PROPER LOCKOUT
PROCEDURE
kas005-1_2013-07-31
This suggested procedure must be performed
EVERY TIME this equipment
with these steps and they will assist in preventing
accidents.
1 Shut down the Drag Conveyor
normal manner.
2 Shut off energy to
the main power source.
3 Turn the power switch back on
to confirm that power has been
deactivated.
4 Attempt to restart
guarantee the power is shut off and then
return the switch to the off position.
5 Using your own lock, lockout all (other)
energy sources which could provide any
power to the Drag
6 With your lock in place test the
disconnect to make certain the power
cannot be restored.
GLOBAL
2016-06-14
is worked on. Stick
in a
the Drag Conveyor
the Drag Conveyor
Conveyor.
INDUSTRIES, INC.
Safety
7 Make absolutely certain the power can't
be supplied by any other means to
Drag Conveyor.
8 All authorized personnel must put his/her
own personal lock on the switch to lock
it in the off position. Everyone must use
only his or her own personal key.
9 Nobody is to return power to
Conveyor
Conveyor
locks have been removed.
Company management needs to look for
maintenance or other employees working on
equipment without following the proper lockout
procedure. Management also needs to look for
any cover or guard not in its proper place. It is the
responsibility of everyone to report any missing
grates, guards, equipment failures, or failures to
lockout. Make certain no cover is removed unless
power is locked out.
at
to
11
until all work on the Drag
has been completed and all
Drag Conveyors
the
the Drag
the
10230011