Black & Decker BWDS Instruction Manual page 9

SET UP & USE
3. Attach REINFORCING BARS to the top and bottom of the left BACK pole and the
top of the LF1-1 as shown below.
Attach one side of a REINFORCING BAR to LB2-1 . Align the holes and Insert 45L
(BUTTERFLY SCREW) through LB2-1 first and then through the reinforcing bar.
Attach one side of a REINFORCING BAR to LF1-1 . Align the holes and Insert 45L
(BUTTERFLY SCREW) through LF1-1 first and then through the reinforcing bar.
Attach one side of the remaining REINFORCING BAR to LB2-2 . Align the holes
and Insert 45L (BUTTERFLY SCREW) through LB2-2 first and then through the
reinforcing bar.
45L
NOTE: The wings of 45L screw must keep vertical rather than horizontal so it does
not obstruct the installation of the DRYER SUPPORT.
CORRECT
LF1-1
REINFORCING BAR
LB2-2
REINFORCING BAR
INCORRECT
45L
LB2-1
45L
Page 9