Black & Decker BWDS Instruction Manual page 13

SET UP & USE
6. Align the holes on the bottom of the DIAGONAL SUPPORT RAIL and
LB2-2 (LOWER LEFT BACK VERTICAL POLE) as shown below. Insert 35M
(BUTTERFLY SCREW) through the DIAGONAL SUPPORT RAIL and LB2-2
(LOWER LEFT BACK VERTICAL POLE).
Align the holes on the bottom of the DIAGONAL SUPPORT RAIL and RB2-2
(LOWER RIGHT BACK VERTICAL POLE) as shown below. Insert 35M (BUTTERFLY
SCREW) through the DIAGONAL SUPPORT RAIL and RB2-2 (LOWER RIGHT
BACK VERTICAL POLE).
LB2-1
RB2-1
ANTI-TIP BRACKETS
RB2-2
LB2-2
Page 13