Page 1
1. Prepare A valid nano-SIM card. MU5001 Let’s Go Getting started with your device. Open the back cover and view the label in the battery slot to get the default information.The following figure is for reference only. 2. Install the Battery 3.
4. Start Your Device 5. Access the Internet Press and hold the power buttonuntil the screen lights up and Wi-Fi:The default Wi-Fi SSID and password can be found thenthe device will connect to the Internet automatically. on the device label. Connect to the Wi-Fi network with your mobile deviceand then access the Internet.
Touch ScreenIcons and Interfaces External antenna Connect the antenna if necessary. connector Press and hold for about 2 seconds to power Power button on your device. nano-SIM card Insert your nano-SIM card. tray Touch screen Description icons Network signal strength Network type New SMS Battery power level...
Trademarks petrol stations or in hospitals. Observe and obey all warning ZTE and the ZTE logos are trademarks of ZTE Corporation. signs, and power off the device in these conditions. Other trademarks and trade names are those of their respective •...
The exposure standard for wireless employs a unit of Limitation of Liability measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. ZTE shall not be liable for any loss of profits or indirect, special,...
Display Grant section www.fcc.gov/oet/ea/fccid after installation. This equipment generates, uses, and can radiate searching on FCC ID: SRQ-MU5001. radio frequency energy and, if not installed and used in accordance with instructions, cause harmful For this device, the highest reported SAR value for near the interference to radio communications.