Husqvarna BB 700 Operator's Manual page 31

General product maintenance
Make sure that the dust hoses are not damaged and free
of blockage.
Make sure that the dust collector is empty and connected
correctly.
Do a check of the burnishing pad.
Do a check of the brush strip.
Make sure that the power cord and extension cable are
in good condition and not damaged.
Do a complete servicing and cleaning of the product.
Clean the product with a damp cloth.
Do a check of the coupling.
To clean the product
• Always clean all the equipment after use. Use a
vacuum cleaner.
• Do not use a high-pressure washer to clean the
product.
• Keep the air openings clean and clear to make
sure that the product always has sufficiently cool
temperature.
• Clean the brush strip with water. Make sure that the
remaining mixture of dust and water is fully removed.
To do a check of the brush strip
• Make sure that the brush strip is not damaged and
that it seals tightly against the floor.
To replace the burnishing pad
WARNING:
parts are fully stopped.
1. Disconnect the product and remove the dust
extractor hose.
1823 - 003 - 13.04.2022
Make sure that all moving
Daily Weekly
*
*
*
X
*
X
2. Tilt the product.
3. Put the product down on the rear supports.
Each 3 Yearly
months
O
*
31