Test Mode - Roland MV-8800 Manual

Jan. 2007
Procedure
1.
While holding down [INSTRUMENTS] and [DISK/USB], power-on the
MV-8800.
* Continue holding down the buttons until "** CD-ROM Update Mode **"
appears.
2.
Place the UPDATE CD-ROM in the CD-RW drive.
The update program on the CD-ROM will be loaded into the MV-8800,
and the update process will be performed. When the update program has
finished loading, the CD-ROM will be ejected.
Never turn off the power while the update is in progress.
When the update process has been completed, the screen will indicate
"Please Reboot OK," and all LEDs will blink.
3.
Turn off the power.
Updating via USB
Required Items
• MV-8800 (main unit and AC power cable)
• Computer equipped with a USB connector
• Update program file "MV8800.PRG"
• USB cable
Procedure
1.
Place the update program file "MV8800.PRG" on the hard disk of your
computer.
2.
Use a USB cable to connect the MV-8800 to the computer, and power-on
the MV-8800.
3.
Press [DISK/USB].
The DISK/USB MENU screen will appear.
4.
Press [F3](USB).
The USB screen will appear.
5.
Press [F5](Connect), and then press [F5](Yes).
The computer will detect the MV-8800's internal hard disk.
6.
From your computer, copy the program file "MV8800.PRG" to the root
folder of the MV-8800's hard disk.
If there is an identically-named file, it will be overwritten.
7.
When copying is complete, stop the USB connection from your computer.
8.
Press [F5](Disconnect).
9.
Power-off the MV-8800.
10. While holding down [SONG] and [DISK/USB], power-on the MV-8800.
* Continue holding down the buttons until "** HD Update Mode **" appears.
The update file will be loaded from the internal hard disk into the MV-
8800, and the update process will be performed.
Never turn off the power while the update is in progress.
When the update process is completed, the screen will indicate "Please
Reboot OK," and all LEDs will blink.
11. Power-off the MV-8800.
14

Test Mode

Required Items
• MV-8800 (with power cable and mouse)
• Foot switch (FS-5U or DP-2)
• Blank CD-R or CD-RW disc
• MV8-OP1
• A device equipped with R-BUS
• A computer that can be USB-connected to the MV-8800
• USB cable
• CD player
• Monitor speakers (with built-in amp)
• Headphones
• MIDI cables
• Audio cables
Entering Test Mode
While holding down [MENU] and [F3], power-on the MV-8800.
* Continue holding down the buttons until "** Service Test Mode **" appears.
After the opening screen appears, the TEST MODE TOP PAGE (FOR
SERVICE) screen will appear.
The upper part of the screen shows the software version and checksum.
Exiting Test Mode
Power-off the MV-8800.
Skipping Between Test Items
The test items are shown in the lower part of the TEST MODE TOP PAGE
(FOR SERVICE) screen. Use the cursor to select an item, and press
[F5](EXECUTE).
If the lower part of the screen for each test item has an indication of PREV,
GOTO TOP, or NEXT, you can perform the following operations.
• If PREV is shown
Press [F1](PREV) to return to the preceding test item.
• If GOTO TOP is shown
Press [F3](GOTO TOP) to move to the TEST MODE TOP PAGE (FOR
SERVICE) screen.
• If NEXT is shown
Press [F5](NEXT) to move to the next test item.
MV-8800