Yamaha STAR 2015 Owner's Manual page 28

Instrument and control functions
Right
4
1. Engine stop switch "
2. "SELECT" switch " /
3. "RESET" switch
4. Start switch " "
Dimmer switch " /
Set this switch to "
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the vehicle
has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the
center position.
TIP
The self-canceling system only oper-
ates when the vehicle is moving, so
that the turn signal lights will not self-
/ "
cancel while you are stopped at an in-
"
tersection.
Horn switch "
EAU12401
Press this switch to sound the horn.
"
" for the high
Engine stop switch "
Set this switch to "
EAU12431
the engine. Set this switch to "
/ "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
". When
Start switch " "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
The engine trouble warning light will
come on when the key is turned to
"ON" and the start switch is pushed,
but this does not indicate a malfunc-
tion.
"SELECT" switch "
EAU12501
"
This switch is used to perform selec-
tions in the odometer and tripmeters,
to set the clock and to set the bright-
EAU12661
ness control mode of the multi-func-
/ "
tion meter unit.
" before starting
See "Multi-function meter unit" on
" to
page 4-4 for detailed information.
"RESET" switch
This switch is used to reset the tripme-
ters, to set the clock and to set the
brightness control mode of the multi-
function meter unit.
4-8
EAU12713
EAU41701
EAU42525
/ "
EAU42536