Cleaning & Maintenance; Declaration; Air Filter; Cleaning The Surface Of The Unit - NewAir NAC12KWH03 Owner's Manual

• If water pump is damaged, continuous drainage can be used by attaching a
drain hose to the unit and placing it in a drain or sufficient receptacle. The
unit can function properly this way as well.
• If water pump is damaged, intermittent drainage can also be used. Under
this condition, pay attention to when the water full indicator light comes on.
Then, connect a drain hose to the lower fixing clip to allow all water in the
water tray to drain out. The unit can function properly this way.
CLEANING & MAINTENANCE

DECLARATION

1. Before cleaning, be sure to power off and disconnect the unit from its
power supply outlet.
2. Do not use gasoline or other chemicals to clean the unit.
3. Do not wash the unit internally directly..
4. If the unit is damaged, please contact the dealer or a repair technician.

AIR FILTER

• The air filter should be cleaned once every two weeks to prevent it from
becoming clogged with dust or dirt.
• Dismounting: Open the air inlet grille and remove air filter.
• Cleaning: Clean the air filter with neural detergent in lukewarm water
(104°F) and let it air dry in a shaded place.
• Mounting: Place the air filter into the inlet grille and replace all components
as they were.

CLEANING THE SURFACE OF THE UNIT

Clean the surface of the unit with a neutral detergent and wet cloth, then wipe
it with a dry cloth.
www.newair.com
EN
22