Firmware Update Procedures - Casio Privia PX-5S User Manual

The procedure for updating the firmware
[Important]
Please pay close attention to the instructions carefully or you may cause your Digital Piano to not function properly.
* Please save any user data to a USB flash drive if necessary.
* After the update, you need to run the "Initialize All".
* Connect the AC adapter to this Digital Piano while you are operating the updating.
* Don't remove the connector of AC adapter or USB flash drive from this Digital Piano during the updating.
* Don't touch any buttons which are not necessary for update process.

Firmware update procedures.

1. Copy the file of firmware, "update.bin" into a USB flash drive.
* Use USB flash drive which is formatted as FAT 32.
* Please put 'update.bin' into the root (top) folder of the USB flash drive.
2. Insert the USB flash drive which mentioned in the procedure 1 into the connector of this Digital Piano.
3. Press [SYS SETTING] button.
4. Select "Information >Ent" from the menu and press [ENTER] button.
5. Select "Update Firmware >Ent" from the menu and press [ENTER] button.
6. After the message, "Update Firmware?" is shown, press [ENTER] button.
7. After the message, "Sure? No/Yes" is shown, press [+/YES] button.
* Don't turn off the Digital Piano while the message "Updating ..." is blinking.
* Don't touch the Digital Piano while the updating which takes about 10 minutes.
* The LED lamps on the eight tone selection buttons will turn on one by one.
* The Digital Piano will restart automatically when the update is completed.
8. Remove the USB flash drive after the Digital Piano restarts.
9. Press the [SYS SETTING] button.
10. Select "Initialize >Ent" from the menu and press [ENTER] button.
11. Select "Initialize All >Ent" from the menu and press [ENTER] button.
12. After the message, "Initialize All?" is shown, press [ENTER] button.
13. After the message, "Sure? No/Yes" is shown, press [+/YES] button.
[Important]
If the update is not completed normally and the Digital Piano does not restart, retry failed update with the following procedure.
1. Remove the connector of AC adapter from the Digital Piano.
2. Remove the batteries from the Digital Piano if they are inserted.
3. Copy the proper "update.bin" into the USB flash drive.
4. Insert the USB flash drive into the Digital Piano steadily.
5. Connect the AC adapter to the Digital Piano.
6. Press the power button.
* If all lamps on the right side of the LCD are lighting, the update starts successfully.
About 10 minutes after the update begun, the Digital Piano will restart.
* If all lamps on the right side of the LCD are flashing, confirm the file "update.bin" or USB flash drive because they may be damaged.
7. Operate from procedure 8 to 13 listed in " Firmware update procedures ". . . .
2