Troubleshooting; Parts List - Central Pneumatic 96068 Set Up And Operating Instructions Manual

Problem
Compressor will not start.
Low pressure.
Overload Protector trips.
Part description
1 Cigarette Lighter Adapter
2 Cord
3 Screw (3 x 25)
4 Power Switch
5 Rear Cover
6 Shockproof Pad
7 Connection Cap
8 Screw (4 x 102)
9 Spring Washer (4mm)
10 Washer (4mm)
11 Cord Sleeve
12 Overload Protector
13 Connection Wire
14 Motor Rear Cover
15 Brush Holder
16 Motor Housing
17 Bearing (608Z)
18 Spring Washer
19 Rotor
20 Spring Washer
Some parts are listed and shown for illustration purposes only,
PleaSe read tHe FolloWing careFullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER.
THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 96068 For technical questions, please call 1-800-444-3353.

trouBleSHooting

Possible cause
Cigarette Lighter Adapter (1) not
1.
securely inserted in vehicle's cigarette
lighter socket.
Power Switch (4) not on.
2.
Vehicle battery not fully charged.
3.
Blown Compressor Fuse.
4.
Blown automotive fuse.
5.
Loose connection(s).
1.
Continuous use too long.
1.

PartS liSt

Part
21 Bearing (608Z)
22 End Cover
23 Inner Hex Screw (4 x 8)
24 Shockproof Pad
25 Air Intake Cover
26 Filter Mesh
27 Screw (3 x 10)
28 Front Cover
29 Offset Shaft
30 Offset Wheel
31 Bearing (626Z)
32 Crank
33 Piston Ring
34 Press Ring
35 Air Intake Slice
36 Rivet
37 Cylinder Liner
38 Radiation Cover
39 Seal Ring
40 Cover
and are not available individually as replacement parts.
Insert Cigarette Lighter Adapter (1) securely.
1.
Turn Power Switch (4) ON.
2.
Charge vehicle battery.
3.
Replace Fuse.
4.
Check automotive manual and replace blown
5.
fuse.
Make sure all connections are tight.
1.
Do not use unit continuously for over 12
1.
minutes. Allow 30 minutes for unit to cool
down after each use.
description
note:
Possible Solution
Part description
41 Seal Ring
42 Air Exhaust Slice
43 Rivet
44 Seal Ring
45 Cylinder Cover
46 Spring Washer (4mm)
47 Screw (4 x 35)
48 Support Ring
49 Pressure Meter
50 Protective Sleeve
51 Air Outlet Tube (8 x 114)
52 Handle
53 Air Outlet
54 Quick Connector
55 Air Hose (8 x 1500)
56 Lock Spring
57 Air Nozzle
58 Glass Fuse (15 Amp)
59 Needle Nozzle
60 (2) Inflator Nozzle
REV 10g
Page 8