Smeg CB2485U Manual page 6

INSTALLATION AND OPERATING CONDITIONS OF THE
Connect to the power supply
•
This appliance should be connected to AC 120V/60Hz supply socket. The socket must be fitted properly
and must be supplied with a power cord with a 3-prong plug and a 15A fuse.
•
It is a legal requirement that the appliance is properly grounded. The manufacturer will not be held
liable for any damage or injury which may result from the failure to fulfill this requirement.
•
Do not use adapters, multiple sockets and cords.
•
See the serial plate at the lower part of the internal wall of the appliance for detailed specifications**.
Disconnecting the power supply
•
Make sure the appliance can be easily disconnected from the outlet, either by pulling the plug out of
the outlet, or by switching off the breaker.
Minimum distances from the heat sources
•
from the electric, gas and other ovens - 30 mm / 1 inch,
•
from oil or coal fired ovens - 300 mm / 12 inches,
•
from built-in ovens - 50 mm / 2 inches
•
Use an appropriate insulation panel between them when there is no possibility of ensuring the specified
distances.
Installation before using the appliance for the first time
•
Make sure there is enough space around the refrigerator to allow it work properly. A free space of 1cm
(1/2 inch) is required on the rear of the appliance so that the air can be circulated to cool the
compressor and condenser. And 30cm (12 inches) space above the refrigerator.
•
Make sure the appliance is placed in level position by adjusting the 2 adjustable front legs.
Shelves
•
The fridge shelves can be moved according to the storage requirements within the fridge section
•
To move the shelf, lift the rear section and then pull it outwards
•
To replace, slide the shelf back into the slot, and then lower the rear section
APPLIANCE
5