Carrier AquaEdge 23XRV Start-Up, Operation And Maintenance Instructions Manual page 20

3
5
6
7
8
9
10
11
6
7
3
8
12
10
a23-1627
4
11 8
Door Open
LEGEND
1 — Wire Harness Assembly, Gate Driver
2 — Current Feedback Device, 1000 A
3 — Wire Harness Assembly, Power Supply, Logic
4 — 80 W Power Supply Assembly
5 — Terminal Block, 2-Position
6 — Cable Assembly, 40-Pin
7 — Cable Assembly, 30-Pin
8 — Wire Harness Assembly, Power Supply, Upper Gate
9 — Inverter Power Interface Assembly
10 — Wire Harness Assembly, Power Supply, Lower Gate
11 — Insulation Sheet
12 — Rectifier Power Interface Assembly
13 — Wire Harness Assembly, Current Feedback Device
*The inverter control assembly (item 16) and rectifier control assembly (item 18) are physically similar but are loaded with different software.
These boards are NOT interchangeable.
Fig. 20 — Control Panel (TB1-15,16 is the high pressure switch)
1
2
4
1
13
14
15
Fig. 19 — Power Module Components (LF2 shown)
ADDITIONAL PLUG CN3
(NOT SHOWN)
CONNECTS VFD RS485
COMMUNICATION
TO PIC6 J10 (MODBUS).
ADDITIONAL CN4
(RUN PERMISSIVE)
HARNESS NOT SHOWN.
23
25
26
24
Door Closed
14 — Wire Harness Assembly, DC Bus Bleeder Resistors
15 — Wire Harness Assembly, Line Sync
16 — Inverter Control Assembly*
17 — Standard I/O Option, 24 V Assembly
18 — Rectifier Control Assembly*
19 — AC Line I/O Assembly
20 — Connector, Terminal Block, 32-Pin
21 — NTC Assembly
22 — Internal Fan
23 — DPI Communications Interface Assembly
24 — RS-485 Communications Assembly (VFD Gateway)
25 — Wire Harness Assembly, Control Sync
26 — Cable Assembly, 20-pin
20
16
20
17
18
25
20
19
21
22