AGFA Crystal-M Imager User Manual page 31

Related Links
Switching off the printer
Safety precautions
Switching on the printer
Transporting the printer
1. Switch off the printer.
2. Disconnect the cables.
3. Move the printer to its destination (with 2, preferably 3 persons!).
4. Reconnect the cables.
5. Switch the printer on.
1
Lift printer from pallet with 3 persons.
2
If only 2 persons are available, lift as
shown below.
3
Put printer on a table. Always put tray
side at front.
Figure 2: Transport possibilities
on page 71
on page 25
on page 68
Crystal-M Imager | Introduction | 31
2
If only 2 persons are available, li
shown below.
3852B EN 20210601 1655