Onkyo HT-R380 Service Manual page 8

MAIN/DSP Update Procedure-1 (How to check
[NOTE] FW version combination
* OSD FW cannot be updated.
* Combination of "OSD_FW and Main_FW" has limitation .
Do not use combination except the list.
*
OSD menu will not appear. Before FW UPdate. check the versions of FWs.
* To upgrade OSD FW version,
Replace Q8105 SPI_MEMORY "EN25Q32A-100HIP" or HDMI Board.
To check FW Versions on the monitor,
While the unit is on, hold down [DISPLAY] and the press [ON/STANDBY].
FW Versions of Main/DSP/OSD will be shown on the monitor like below.
Main:
DSP:
OSD:
CHECKSUM:
To check FW versions on Front Display,
While the unit is on, hold down [DISPLAY] and the press [ON/STANDBY].
1.
Main FW Version
e.g.
M:1.07/10413AL
2.
While Main FW Version is shown, press [+(TONE)].
DSP FW Version
e.g.
D :1 .0 2 /1 0 4 1 6 a 3 8
OSD FW Version will not be shown on Front Display.
Version Information
1.07/10413AL
1.02/10419a38
1.01/10204A0
27D3879D
will be shown on Front Display.
* It depends on the version.
will be shown on Front Display.
* It depends on the version.
TX-SR308/ 508 HT-R280/ 380/ 538/ 580/ HT-RC230
FW Version)
FW Version Combination "As of September, 2010"
Main DSP
1.04 1.00
1st Lot
1.05
1.01
1.06
Later Lots
1.07
1.02
1.08
1.09
marking is the S/N end
ON/STANDBY
+(TONE)
DISPLAY
OSD marking
1.00
NO
A
B
1.01
C
D
E