Onkyo HT-R380 Service Manual page 10

MAIN/DSP Update Procedure-3
Update Procedure
While the unit is on, hold down [DISPLAY] and then press [ON/STANDBY].
1.
Main FW Version will be shown on Front Display.
e.g.
M:1.07/10413AL
2.
While Main FW Version is shown, press [+(TONE)].
DSP FW Version will be shown on Front Display.
e.g.
D :1 .0 2 /1 0 4 1 6 a 3 8
3. While DSP FW Version is shown, press [RETURN].
T OT A L / AU TO
* TUNING key changes "AUTO "
（"AUTO" means "COAX1" or "OPT1" will be automatically detected.
* TUNING key changes "TOTAL" "MAIN" "DSP."
（TOTAL = MAIN+ DSP）
4. When MAIN and DSP FWs are upgraded at the same time, select
For separate upgrade, select
S/PDIF Update..
5. PC upgrade: Play back the stored wav file in your PC.
CD upgrade: Play back the FW CD-R with the connected CD player.
[N OT E] M ake sur e t ha t
About 15 seco nds l at e r, t he mes sage w il l c h a n g e f r o m
When "Writing..." will not be shown, the output music data is not correct.
Check the connection and settings.
S/PDIF Update..
Writing...
S/PDIF Update..
FW-Update 00000
FW-Update FF000
OK:Sum=********
6. Unplug AC cord and plug it again. Press
C le a r
7. Make sure that "Clear" is shown and the unit is turned into the Standby mode.
8. Make sure that the FW versions are the latest.
* It depends on the version.
* It depends on the version.
"COAX1" "OPT1."
"MAIN" or "DSP" and press "ENTER."
"PCM " i s sho wn be fore s ta r t in g p l a yb a ck .
P la yb ack st ar ts. (P layba ck time: ab out 1:1 5)
(about 15 seconds)
(about 20 seconds)
(about 30 seconds)
After playback finishes, update will start.
(about 18 minutes)
(just after "FF000" is shown)
"********" depends on the version.
[ON/STANDBY].
TX-SR308/ 508 HT-R280/ 380/ 538/ 580/ HT-RC230
ON/STANDBY
+(TONE)
"TOTAL / AUTO" and press "ENTER."
It takes about 15 minutes.
S/PDIF Update...
TUNING
ENTER
DISPLAY
RETURN
to Writing...