Sidestand - Yamaha BOLT 2019 Owner's Manual

Bolt R-Spec
(a)
(b)
1
1. Spring preload adjusting ring
2. Stopper
Spring preload setting:
Minimum (soft):
1
Standard:
2
Maximum (hard):
5
WARNING
These shock absorber assemblies
contain highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assemblies.
 Do not tamper with or attempt
to open the cylinder assemblies.
 Do not subject the shock ab-
sorber assemblies to an open
2
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
5
4
3
2
pressure.
1
 Do not deform or damage the
cylinders in any way. Cylinder
damage will result in poor
damping performance.
 Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
EWA10232
Instrument and control functions

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
4-14
WARNING
EAU15306
4
EWA10242