Clutch Lever - Yamaha BOLT 2019 Owner's Manual

has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the
center position.
TIP
The self-canceling system only oper-
ates when the vehicle is moving, so
that the turn signal lights will not self-
cancel while you are stopped at an in-
tersection.
Horn switch " "
Press this switch to sound the horn.
Engine stop switch " /
Set this switch to " " (run) before
starting the engine. Set this switch
to " " (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
Start switch "
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
The engine trouble warning light will
come on when the start switch is
pushed, but this does not indicate a
malfunction.
"SELECT" switch
This switch is used to perform selec-
EAU12501
tions in the odometer and tripmeters
and to set the clock of the multi-func-
tion meter unit.
EAU12663
See "Multi-function meter unit" on
"
page 4-3 for detailed information.
"RESET" switch
This switch is used to reset the tripme-
ters and to set the clock of the multi-
function meter unit.
See "Multi-function meter unit" on
page 4-3 for detailed information.
Instrument and control functions
EAU12713
"

Clutch lever

EAU85200
1. Clutch lever
EAU55701
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
EAU55711
tion circuit cut-off system. (See page
4-15.)
4-6
EAU12822
1
4