Life Fitness Insignia Series Owner's Manual page 37

Upon entering the mode, the Total Time will be displayed (flashing digits) for 15 seconds followed by the Total
Repetitions (non-flashing digits) for 15 seconds.
• Total Time is the time of active workout use over the entire life of the product.
• Total Time is displayed in hours.
• Example: A display of "04 & 8:23" means 04,823 or 4,823 hours of use.
• Total Repetitions is the number of repetitions over the entire life of the product.
• Total Repetitions are displayed in the hundreds.
• Example: A display of "04 & 8:23" means 04,823*100 or 482,300 repetitions.
After Total Repetitions are displayed for 15 seconds, the console enters Sleep Mode.
NOTE: The Repetition Counter window (1) remains blank until the Time Counter window (2) exceeds 9:99.
NOTE: The Repetition and Time Counter can NOT be reset.
Repetition Counter Low Battery
The three digit time counter display includes a low battery indicator symbol. The symbol shall be active in all modes
when the battery voltage reaches the following points:
1. When battery voltage drops below 2.4V the symbol shall flash on and off in all modes and will continue to flash as
long as the battery voltage remains below 2.6V.
2. If the battery voltage were to increase over 2.6V the battery indicator shall turn off again until the voltage would
again drop below 2.4V.
3. At around 2.0V, the display and processor no longer are able to keep running and the entire console will be off
until the batteries are replaced.
Troubleshooting
PROBLEM
Low battery icon is flashing.
Display does not turn on when you pickup the weight
stack.
Rep counter turns ON when you pick up the head plate
but does not count reps.
TROUBLESHOOTING
Replace batteries (requires two AA)
• Replace batteries.
• Check the magnet on the head plate is still in position
and the reed switch (marked "NC") is still positioned
next to the magnet.
• Check connections at back of console for battery and
switch assembly.
• Replace the console.
NOTE: A console comes with the magnet and reed
switch assembly.
• Make sure you are doing a full repetition. Magnet
must go up past the counter reed switch (marked
"NO") and back down past it to count ONE repetition.
• Check for broken or cut wires. If broken or cut wires
found, replace the console.
NOTE: Console includes all wiring.
Page 35 of 51