Rider's Seat And Hump Cover - BMW S 1000 RR Rider's Manual

The handlebar grips can be
heated at two different levels.
The second stage 2 is intended
for rapid heating of the handlebar
grips. Once they are warm you
should switch back to the first
stage.
Second step: 100 % heat-
ing capacity
First stage: 50 % heater
output
If no further changes are made
the selected heating level is
adopted as the setting.
Rider's seat and hump
cover
Remove rider's seat
Press cover of rider's seat
above screws 1 forward some-
what and hold in place.
Remove screws.
Push the rider's seat forward,
lift it at the rear and remove it.
When doing so, make sure that
the trim panel is not damaged
by the screws.
Lay the rider's seat on a clean
surface with the upholstered
side down.
Installing rider's seat
Insert rider's seat into the fix-
ture 2, then position it over the
screw sockets 3. When do-
ing so, make sure that the trim
panel is not damaged by the
screws.
4
59
z