BMW S 1000 RR Rider's Manual page 79

FRONT DMP Adjusting
The adjust damping, briefly
press TRIP 1 or SET 2 repeat-
FRONT
edly until in line 3
displayed and in line 4
(Damping).
NOTICE
Display deviates when a spring
travel sensor for front forks is
used (racing accessory).
Press and hold SET 2.
DMP:
The value next to
flashes.
Adjust damping as desired with
TRIP 1 and SET 2.
+1 ... +7
in a maximum of seven steps
(harder).
-1 ... -7
in a maximum of seven steps
(softer).
0
: Factory setting
Press and hold SET 2 until dis-
played value no longer flashes.
The value for the current riding
mode is saved.
Performing zero position
is
alignment
DMP:
with Dynamic Damping Control
OE
(DDC)
Place motorcycle on side stand
or a suitable auxiliary stand.
During the alignment, do not sit
on the motorcycle and remove
any cargo or luggage.
Select submenu (
Submenu
is selected.
: Damping increase
: Damping decrease
111).
SETUP DDC-SYS
To set the zero position, briefly
press TRIP 1 or SET 2 until
CALIB
(Calibration) is dis-
played in line 4.
Press and hold SET 2 until
CALIB
starts to flash.
CALIB
flashes.
Zero position is adjusted.
5
77
z