Sony DSC-QX10 Service Manual page 33

5. Install the 1 Frame Assy so the Lever positions match.
Note: Confirm that the Barrier closes when the 1 Frame Assy is pushed.
1 Frame Assy
Lever
6. Set the 3 Group Assy in the groove in the orientation where the Flexible Board comes to the nearly opposite side of the cabinet number
on the Cam Tube A.
Note: Be sure to set the 3 Group Assy at the correct insertion position.
7. Push the 3 Group Assy until the three claws lock.
Flexible Board
Cam Tube A
Cabinet Number
8. Install the Rotary Cam Tube to the Rotary Tube aligning the semicircular cutout with the Gear edge.
9. Install the Stationary Tube Assy at the position shown in the figure as a guideline.
Note: Be sure to install the Rotary Cam Tube with the semicircular cutout and the Gear edge set in the "OK" state shown in the figure.
10. Install the Main Body so that the Flexible Board position matches the hole to pass the Flexible Board.
Semicircular
Rotary Cam Tube
Cutout
Gear Edge
DSC-QX10
Lever
3 Group Assy
Claws
OK
NG
Rotary Tube
Claws
Stationary Tube Assy
4-15
Main Body