Magnum 250Lx Push-Pull - Lincoln Electric POWER MIG 255XT Operator's Manual

ACCESSORIES
MAKE A WELD WITH THE MAGNUM 250LX
PUSH-PULL GUN
1. POWER MIG® 255XT
a. Set machine to non spool gun operation.
b. Turn the POWER MIG® 255XT input power ON
adjusting the voltage control at the front panel.
c. Adjust the wire speed control on the front panel.
Refer to the procedure decal mounted at the
inside of the wire feeder compartment cover.
2. Magnum 250LX Push-Pull Gun:
a. Set machine to non spool gun operation.
b. Closing Push-Pull gun trigger starts the Push-
Pull gun welding and makes all guns connected
to the machine electrically "Hot".
c. The Push-Pull Adapter will provide power and
control to the "Pull" motor of the Push-Pull gun
and the POWER MIG® 255XT will control its
wire drive.