Settings For The Sound (Audio Setup) - Sony DVP-NS57P Operating Instructions Manual

Settings for the Sound
(AUDIO SETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 58).
The default settings are underlined.
AUDIO SETUP
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
48kHz/96kHz PCM:
AUDIO DRC (Dynamic Range Control)
(DVDs only)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DRC."
This function affects the output from the
following jacks:
– LINE OUT L/R (AUDIO) jacks
– DIGITAL OUT (COAXIAL) jack only
when "DOLBY DIGITAL" is set to "D-
PCM" (page 63).
STANDARD Normally, select this position.
TV MODE
Makes low sounds clear even if
you turn the volume down.
WIDE
Gives you the feeling of being
RANGE
at a live performance.
DOWNMIX (DVDs only)
Switches the method for mixing down to 2
channels when you play a DVD which has
rear sound elements (channels) or is recorded
in Dolby Digital format. For details on the
rear signal components, see "Checking the
audio signal format" (page 41). This function
affects the output of the following jacks:
– LINE OUT L/R (AUDIO) jacks
– DIGITAL OUT (COAXIAL) jack when
"DOLBY DIGITAL" is set to "D-PCM"
(page 63).
DOLBY
SUR-
ROUND
NORMAL
Selects if audio signals are output via the
DIGITAL OUT (COAXIAL) jack.
ON
STANDARD
DOLBY SURROUND
ON
OFF
D-PCM
OFF
48kHz/16bit
Setting the digital output signal
Switches the method of outputting audio
signals when you connect a component such
as an amplifier (receiver) or MD deck with a
digital input jack.
For connection details, see page 19.
Select "DOLBY DIGITAL," "DTS," and
"48kHz/96kHz PCM" after setting
"DIGITAL OUT" to "ON."
If you connect a component that is
incompatible with the selected audio signal, a
loud noise (or no sound) may be heard from
the speakers, risking damage to your ears or
speakers.
Selects the type of Dolby Digital signal.
D-PCM
DOLBY
DIGITAL
Normally, select this position.
Multi-channel audio signals are
output to 2 channels for enjoying
surround sounds.
Multi-channel audio signals are
downmixed to 2 channels for use
with your stereo.
DIGITAL OUT
Normally, select this position.
When you select "ON," see
"Setting the digital output signal"
for further settings.
The influence of the digital circuit
upon the analog circuit is
minimal.
DOLBY DIGITAL (DVDs only)
Select this when the player is
connected to an audio
component without a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
"DOWNMIX" item in
"AUDIO SETUP" (page 63).
Select this when the player is
connected to an audio
component with a built-in
Dolby Digital decoder.
US
63
,continued