Table of Contents
Advertisement
Quick Start
All manuals and user guides at all-guides.com
If you are familiar with both the operation of a 35mm slide
projector and your video display, you may follow an
abbreviated start-up procedure.
Before starting, review the precautions on page 6.
To "Quick Start" the VideoMate 5000, proceed as follows:
1. Unwind the cord under the base of the unit and plug it
into a suitable power supply.
2. Connect your TV monitor to the Y/C (S-Video) and/or
RGB/Sync output connectors of the VideoMate. The
composite video connector can only be used if the Y/C
output is switched OFF (see Installation section).
3. Load the slide tray onto the projector.
4. Turn the TV monitor on and set the VideoMate power
switch to HIGH.
5. Select a relatively "white" slide to represent the highest
signal level the electronics must accommodate.
Adjust the iris (I) and the TV monitor to produce a
suitable image. The focus (F) should also be adjusted
at this time.
NOTE: A very dark slide may require readjustment of
the iris, but a setting can usually be reached that
produces an acceptable display throughout a range of
slides.
6. Adjust the zoom lens control to achieve the correct
image size. This zoom lens can be zoomed in on
slides for increased magnification, but cannot be
zoomed out to view whole vertical slides.
Quick Start
9
Advertisement
Table of Contents
