Table of Contents
Advertisement
Installing and replacing a fan tray
You can install and replace the back-to-front airflow fan tray and
front-to-back airflow fan tray in the same way. For more information, see
"Installing a fan
Installing a fan tray
IMPORTANT:
Before installing a fan tray, make sure that the airflow direction of
the module meets the ventilation requirement at the installation site.
Follow these steps to install a fan tray:
Step1
Wear an ESD-preventive wrist strap, and make sure that it
makes good skin contact and is properly grounded.
Step2
As shown in callout 1 of
the captive screws on the blank filler panel of the fan tray slot,
and then remove the blank filler panel.
Unpack the fan tray.
Step3
Step4
As shown in callout 2 of
hands with the upside (marked with an airflow direction label)
on top, gently push the fan tray into the slot along the guide
rails until the fan tray completely seats into the slot.
Step5
Use a Phillips screwdriver to fix the captive screws on the fan
tray to secure it into the switch chassis.
Step6
When the switch is running, check the status LED of the fan tray.
If the LED displays green, the installation is correct.
tray" and
"Replacing a fan
tray."
Figure
3, use a screwdriver to loosen
Figure
3, holding the fan tray with both
6
Advertisement
Table of Contents
