Sherwood Newcastle RX-765 Operating Instructions Manual page 14

Select the desired preset number (1~30)
and press the MEMORY button.
3
TUNE TUNE
MEMORY
or
• When using the NUMERIC buttons on the remote
control.
Examples) For "3" :
3
within 2 seconds
For "15" :
1
For "30" :
0
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is stored
automatically without pressing the MEMO button.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If "MEMO" goes off, start again from the above step 2.
Tuning to preset stations
After selecting the tuner as an input
source, select the preset mode.
1
T/P MODE
T/P
or
• Then "PRESET" lights up.
Listening to FM stereo broadcasts
• While listening to FM broadcasts,
• Each time this button is pressed,
the FM mode changes as follows:
Stereo mode : "ST" lights up.
Mono mode : "ST" goes off.
• When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound.
T/P T/P
TUNE TUNE
MEMO
+
TREBLE TREBLE + BASS BASS
+
MUTE MUTE
VOL. VOL.
TUNE TUNE TUNE TUNE
MEMO MEMO
+
FM MODE FM MODE P.SCAN P.SCAN
VOL. VOL.
The following items, set before the receiver is turned
off, are memorized.
• INPUT SELECTOR settings
5
• Preset stations,etc.
• If the electricity fails or the AC input cord is
disconnected for more than 2 weeks, they are all
cleared. So you should memorize them again.
POWER ON
STANDBY
DIMMER SLEEP
SPEAKER
A B
CD TAPE VIDEO TV/AUX
REPEAT
TUNER
A/B
INTRO
A
DECK SEL. DECK SEL. TAPE
B
TREBLE TREBLE + BASS BASS
+
T/P T/P MUTE MUTE
• When using the NUMERIC buttons on the remote
VOL. VOL.
control.
TUNE TUNE TUNE TUNE
MEMO MEMO
+
FM MODE FM MODE P.SCAN P.SCAN
VOL. VOL.
POWER ON
STANDBY
1 2 3 4 5
• When selecting the desired preset number with the
SPEAKER DIMMER SLEEP
6 7 8 9 0
A B
NUMERIC buttons, the desired preset station will be
CD TAPE VIDEO TV/AUX
tuned to automatically without selecting the preset mode.
REPEAT TUNER
REMOTE CONTROL RM-110 A/B
INTRO
A
DECK SEL.
Scanning preset stations in sequence
B
TREBLE BASS
T/P MUTE
VOL.
FM MODE
TUNE TUNE TUNE
MEMO
FM MODE FM MODE P.SCAN
VOL.
1 2 3 4 5
6 7 8 9 0
• The receiver will start scanning the stations in the preset
REMOTE CONTROL RM-110
sequence.
• At the desired station, press this button again to stop
scanning.
1 4
Repeat the above steps 1 to 3 to memorize
other stations.
4
MEMORY BACKUP FUNCTION
Note
Select the desired preset number.
2
or
TUNE
TUNING/PRESET
Examples) For "3" :
3
within 2 seconds
For "15" :
1
POWER ON
STANDBY
For "30" :
0
DIMMER SLEEP
SPEAKER
A B
VIDEO
CD TAPE TV/AUX
REPEAT
TUNER
A/B
INTRO
A
DECK SEL.
B
+
TREBLE TREBLE BASS BASS
+
T/P T/P MUTE MUTE
VOL. VOL.
TUNE TUNE TUNE TUNE
MEMO MEMO
+
FM MODE FM MODE P.SCAN P.SCAN
VOL. VOL.
1 2 3 4 5
6 7 8 9 0
REMOTE CONTROL RM-110
POWER ON STANDBY
DIMMER SLEEP
SPEAKER
A B
CD TAPE VIDEO
TV/AUX
REPEAT
TUNER
A/B
INTRO
A
DECK SEL. DECK SEL. TAPE
B
TREBLE TREBLE + BASS BASS
+
T/P T/P MUTE MUTE
VOL. VOL.
TUNE
+
TUNE TUNE TUNE TUNE
MEMO MEMO +
FM MODE FM MODE P.SCAN P.SCAN
VOL. VOL.
1 2 3 4 5
6 7 8 9 0
5
REMOTE CONTROL RM-110
P.SCAN